+248.735.7000
office@USIgroups.com

Tag: Manufacturing

Leading Edge August 2021

                           Cost of Corrosion “Over $1.1 Trillon yearly, roughly 2.1 percent of our GDP” Project: Clarifier Tank Repair and Upgrade   One of North America’s largest flat role steel producers had a clarifier at its continuous caster was starting to leak and needed…
Read more

Leading Edge July 2021

EPA Raises Environmental Civil Penalties for 2021 U.S. EPA slightly increased its maximum monetary civil penalties for violations of air, water, chemical, and hazardous waste programs on December 23, 2020. The increases in maximum penalty amounts were implemented to keep pace with inflation. The new maximum penalty amounts shown below will  apply to environmental violations…
Read more

Crusher Shaft Repair

The Challenge This shaft of a single toggle jaw crusher was exhaustively used in a mining facility.  The shaft weighed 3,000 pounds and originally cost over $20,000.  The journal areas had been excessively worn as a result of the aggressive working environment and many years of use. Four areas of heavy wear were identified for…
Read more

Leading Edge May 2021

Are you ready for the damage caused by ground water intrusion or leaking pipes?

In Place HVAC Shaft Repair

The Challenge This Children’s Hospital had a large shaft that was damaged with extreme wear. They were looking at a high-cost project that would take weeks or months to execute. Large holes in the walls or roof would have been created (and then fixed!) to lift out the damaged part and bring in a long-lead…
Read more

Spare Part – Valve Corrosion Protection

The Challenge This major natural gas company needed a solution to keep their larger critical spare parts corrosion free while in storage for an unknown future date of use. They need to keep larger, more expensive spare parts on hand, and ready to use, because when a part like that is needed for replacement, they…
Read more

Crude Oil Pit Rebuild & Protection

The Problem This old crude oil pit was severely decayed. Unconventional Solutions recommended removing the existing concrete and replacing it with 3M Scotchkote Screed RS 820. The customer, however, requested a more economical solution. The Substrate Concrete The Solution To accommodate the customer’s request, Unconventional Solutions suggested the use of fine sand and RESICHEM 502…
Read more

Power Plant Warehouse Floor Repair

The Challenge Years of heavy use, forklift traffic, water, cleaning chemicals and salts had severely damaged this floor at the primary warehouse of a Michigan Power Plant. The customer needed a long term solution that could be installed over the weekend, during a unit outage, to minimize inconvenience and downtime and save money by not…
Read more

Leeching Trench Repair

The Challenge This Refinery had a concern with soil contamination by ethanol solvents and hydrocarbons. They contacted Unconventional Solutions for a system that would repair, protect, and upgrade the trench to give them a long-term solution to protect the environment without costly tear-out and re-pour of the entire trench. The Solution The affected area was…
Read more

PCB Encapsulating System

The Challenge This Major Electrical Company Service Centers floor had PCB  (Polychlorinated Biphenyl’s) contamination from transformer oil spilling on it, as back in the 70’s, a crew had pulled a leaking transformer along the floor. They wanted to become the hero for their employees by providing a safe environment to work.  They avoided paying Millions…
Read more