Chlor*Rid DTS Soluble Salt Remover Ready to Use/Direct to Surface


CHLOR*RID DTS is an organic bonding chemical blend which aids in the removal of chlorides, sulfates and nitrates and most other soluble salts; contains no volatile organic compounds (VOC) and is biodegradable. CHLOR*RID DTS is recommended as a hand wash solution prior to application of primers or coatings on a variety of surfaces, including ferrous and nonferrous metals, wood, plastics, and others. For a full list contact manufacturer.

Ready to Use – Direct to Surface

Chlor*Rid – DTS Direct to Surface – 5 gallon each.


CHLOR*RID is added to the water of the pressure washer, usually in a dilution ratio of 1:100. (See Testing below) Add CHLOR*RID by means of a metering pump or add to a reservoir water supply. A siphon device may be used, but most such devices lack dilution control and positive input. Use potable water or other approved source. A minimum 3000 p.s.i. pressure washer is recommended. A zero degree rotating nozzle is also recommended. Flush washer and lines prior to application. Can also be applied through UHP waterjetting equipment. Hold pressure nozzle perpendicular to the surface and preferably 4 to 8 inches away to ensure all surfaces are washed with direct high pressure. In areas of deep pitting, slow the wash speed to enable better cleaning. Do not rinse. Typical application rate is 300 to 1000 Sq. Ft. per gallon of CHLOR*RID.

5 gallon ready to use.

Additional information

Weight 55 lbs


There are no reviews yet.

Be the first to review “Chlor*Rid DTS Soluble Salt Remover Ready to Use/Direct to Surface”